Sponsored in part by...
Visit my Facebook
chopperaddict , R/C, helicopter ,
trex , interceptor , int400 , blade 400 ,
training , repairs , setups , sales ,
information , tips & tricks , help
custom builds , scale builds ,
spare parts , tutorials , info ,
align , t-rex , kds , copterx ,
copter-x , alien command ,
Helicommand , Flymentor ,
auto pilot systems , radio setup ,
kit building , Upgrades ,
hover training , setup training ,
Flight training , Phoenix training ,
HeliArtist , painting , detailing ,
D12 - RADIO - I am not sure
how to set BOTH ends of the Travel Adjust in my radio ?
something that quite few pilots fail to understand, but it is
actually quite simple.
The trick is
to realise that the value that shows when you access the Travel
adjustment screen the settings you can see are ONLY FOR ONE
DIRECTION of the servo travel. If you watch it for let's say
the ELEVATOR, try setting the value it shows to something else, and
then move the elevator stick up or down until the value
changes.... then move the stick the other way and the newly
changed value will reappear.
So by holding
the stick in either direction while adjusting the end points, you
can adjust the maximum travel point in each direction separately.
THIS HELPS ... ?
Why not check me out on Facebook ?
to Questions Page